Netopia CLI 874 Manuale Utente

interface t1 id framing { d4 | esf } 
show interface t1 id framing 

These commands set or display the framing mode for the specified T1 WAN inter face.

interface t1 id encoding { ami | b8zs } 
show interface t1 id encoding 

These commands set or display the line encoding for the specified T1 WAN inter face.  

Note:

If this command changes the line encoding from b8zs to ami and there are two or more contiguous 

Nx64k channels in use, the channel data rate will be changed to Nx56k.

interface t1 id operation line type { normal | copper-mountain } 
show interface t1 id operation line type 

These commands set or display the operation mode for the specified T1 WAN inter face. The keyword 
copper-mountain should be specified when connected to a Copper Mountain DSLAM T1 line card; the keyword 
normal should be specified in all other situations.

interface t1 id prm-enable { yes | no } 
show interface t1 id prm-enable 
no interface t1 id prm-enable

These commands set or display whether or not ANSI PRMs are sent on the specified T1 WAN inter face.

interface t1 id rfc1973 enable { yes | no } 
show interface t1 id rfc1973 enable 
no interface t1 id rfc1973 enable 

These commands set or display whether or not PPP in Frame Relay (RFC1973) is enabled on the specified T1 
WAN inter face.

interface t1 id rfc1973 dlci { 16..991 } 
show interface t1 id rfc1973 dlci 

These commands set or display the DLCI used for PPP in Frame Relay (RFC1973) on the specified T1 WAN 
inter face.

interface t1 id rfc1973 lmi { annexa | annexd | ansi | ccitt | lmi | none } 
show interface t1 id rfc1973 lmi 
no interface t1 id rfc1973 lmi

These commands set or display the Local Management Inter face (LMI) type for PPP in Frame Relay (RFC1973) 
on the specified T1 WAN inter face.