IBM 09-0572-000 Manuale Utente

C

HAPTER

 4: S

TANDARD

 I

NSTALLATION

 

AND

 C

ONFIGURATION

To change the software option settings, follow these steps:

1 Make sure the 3C619C adapter has been properly installed 

in your PC (refer to Chapter 2 for instructions).

2 Boot your PC under DOS, version 3.2 or later.

When you configure adapters, memory conflicts may occur. 
To help prevent this, follow these rules:

a Do not load network drivers. 

b Be aware that terminate and stay resident programs 

(TSRs) may cause memory conflicts. 

c If you are using a memory management utility, you must 

inform it of the address ranges used by the adapter. For 
example, add an exclude parameter to the EMM386 
device statement in the CONFIG.SYS file such as:

DEVICE=C:\EMM386.EXE NOEMS X=D800-DBFF

3 Place the 

TokenDisk diskette in a floppy drive on your PC 

and make that drive the active drive. For example, type:

4 Type at the prompt:

5 When the AutoLink Information screen appears, press [Enter].

6 From the main menu, select Configuration/Diagnostic/ 

Troubleshooting.

Memory Mode

16 bit

16 bit

I/O Mode

16 bit

16 bit

IRQ Driver Type

Edge Triggered

AutoSwitch

Disabled

Boot PROM

Disabled

Zero Wait State

Enabled

Table 4-2   Initial 3Com and IBM Mode Option Settings (continued)