Nortel Networks AN/DC Manuale Utente
Installing and Operating AN/DC and ANH-8/DC Systems
1-6
312410-A Rev 00
Installing the AN/DC
With all cabling attached, you can install the AN/DC in any of the following ways:
•
Position the AN/DC on a flat, sturdy surface.
•
Install the AN/DC in an electronic enclosure rack.
•
Mount the AN/DC on a wall.
The following sections provide instructions for each option. Refer to the
appropriate section when positioning your AN/DC.
appropriate section when positioning your AN/DC.
Positioning the AN/DC on a Flat Surface
To position the AN/DC on a flat surface:
1.
Make sure that the surface is large enough for the AN/DC to operate
properly.
properly.
The surface must be sturdy enough to support the combined weight of the
AN/DC and any cables you connect.
AN/DC and any cables you connect.
2.
Peel the paper backing off the four rubber feet supplied with the AN/DC
and attach them to the embossed feet on the bottom of the AN/DC.
and attach them to the embossed feet on the bottom of the AN/DC.
3.
Set the AN/DC in the chosen location.
You can now connect the network cables to the AN/DC. Go to the section
“
“
,” later in this chapter.
Installing the AN/DC in a Rack
For this procedure, you need
•
Mounting hardware that came with the AN/DC shipment
•
An electronic enclosure rack
•
Phillips screwdriver
Note:
If the rack’s rail does not have threaded holes, you must supply and
attach four cagenuts.