Nortel Networks AN/DC Manuale Utente
Installing and Operating AN/DC and ANH-8/DC Systems
2-10
312410-A Rev 00
Mounting the ANH-8/DC on a Wall
For this procedure, you need
•
Two flange brackets and four #6 roundhead screws (shipped with the
ANH-8/DC)
ANH-8/DC)
•
Four to eight wall anchor screws (not shipped with the ANH-8/DC)
•
A Phillips screwdriver
Complete the following steps:
1.
Attach a flange bracket to both sides of the ANH-8/DC.
On each side of the chassis:
a.
With the longer bracket piece lying flat, align the holes in the smaller
end of the bracket with two of the mounting holes on the side of the
ANH-8/DC
end of the bracket with two of the mounting holes on the side of the
ANH-8/DC
.
b.
Insert a screw through each hole and into the ANH-8/DC.
c.
Tighten the four screws with a Phillips screwdriver.
Figure 2-5.
Attaching Flange Brackets to Wall-Mount the ANH-8/DC
2.
Place the ANH-8/DC with installed brackets against the wall to determine
the location of the anchor screws
the location of the anchor screws
Note:
The sides of the ANH-8/DC include screw holes at both ends, providing
three ways to attach the brackets for wall-mounting. You can attach both
brackets toward the front of the ANH-8/DC, both brackets toward the back, or
you can offset the two brackets, as shown in
brackets toward the front of the ANH-8/DC, both brackets toward the back, or
you can offset the two brackets, as shown in
, for the most secure
installation.
Screws
(2 places)
(2 places)
Screws
(2 places)
(2 places)
Access Node Hub
Front of ANH
Back of ANH
AN0042A