Nortel Networks AN/DC Manuale Utente
Installing and Operating AN/DC and ANH-8/DC Systems
3-18
312410-A Rev 00
8.
When the Technician Interface prompt reappears, type the following
command and press the Return key to exit the Technician Interface:
command and press the Return key to exit the Technician Interface:
logout
Once the install script completes, the router starts bridging and routing traffic.
9.
When you boot the router, its LEDs flash in a particular order. To
interpret the LED sequence and troubleshoot any potential problems,
refer to Chapter 4.
interpret the LED sequence and troubleshoot any potential problems,
refer to Chapter 4.
After configuring the router network interface, you can replace the console
connection with a modem connection to enable remote dial-in access.
connection with a modem connection to enable remote dial-in access.
Note:
If the router tries to Local Boot and cannot get a software image, it
attempts to Netboot once. If both the Local Boot and Netboot attempts fail, the
AN Diagnostic Monitor Login prompt appears on the console. In this case, you
or your network administrator must troubleshoot the problem.
AN Diagnostic Monitor Login prompt appears on the console. In this case, you
or your network administrator must troubleshoot the problem.