Motorola IH5 Manuale Utente

1-4

Computer Group Literature Center Web Site

Hardware Preparation and Installation

The following equipment is required to complete an MCPN750A system:

❏

CompactPCI system enclosure

❏

System console terminal

❏

Operating system (and/or application software)

❏

Disk drives (and/or other I/O) and controllers

❏

Transition module (TMCPN710 or TM-PIMC-0001) and 
connecting cables

MCPN750A baseboards are factory-configured for I/O handling via a 
TMCPN710 or TM-PIMC-0001 transition module. There are currently 
eight MCPN750A models corresponding to the five separate memory 
configurations, two processor speeds and front or rear ethernet I/O. Either 
one of the aforementioned transition modules support all models of the 
baseboard. Refer to the subsections on the MCPN750A and transition 
module installation for more information.

Note that the debugger initializes 
the MCPN750A

You may also wish to obtain the PPCBug Firmware 
Package User’s Manual, listed in Appendix B, 
Related Documentation.

Initialize the system clock.

Using the Debugger, Debugger Commands, the 
SET command

Examine and/or change 
environmental parameters.

and 

Program the board as needed for 
your applications.

MCPN750A CompactPCI Single Board Computer 
Programmer’s Reference Guide, listed in Appendix 
B, Related Documentation.