Primera Technology AP360 Manuale Utente

4.  Press the Foot Switch to apply the labels.  Both labels will be applied 

without pressing the Foot Switch again.

To set a value for another memory location, repeat this procedure.

If you intend to apply two labels to the same container you will typically want to center the 

second label so that you have the same distance between each label on both sides.  Use this 

formula to calculate the proper distance setting (see Section 4B).

1. First Calculate the circumference of your container.

2.  Now subtract the width of both front and back labels from the circumference and 

divide by two.

(circumference - width of front label - width of back label) / 2

3.  Subtract the distance between the labels on the liner (the distance between the labels while they

are still attached to the roll) from the value received in step 2. 

If your bottle is 3 inches in diameter, your front label is 4 inches wide, your back label is 

2.5 inches wide, and the distance between the labels on the liner is .12, the distance value 

to enter would be 1.34 inches.

3 x 

π

= 9.42

(9.42 - 4 - 2.5)/2 = 1.46 - 0.12 = 1.34

By default the AP362 Label Applicator will begin to count labels.  This

count will be displayed on the LCD.  If you press any of the buttons on

the control panel the label count will momentarily disappear.  It will

reappear ten seconds after the button is pressed.  (Figure 4.3.)

Press and hold the Recall/Reset Button for five seconds to reset the label

counter to zero.