Land Pride RCPM2660 Manuale Utente
24
Section 1: Assembly & Set-up
RCP2660, RCPM2660, RCP3060 and RCPM3060 Parallel Arm Rotary Cutter 316-111M
12/16/08
Land Pride
Gauge Wheel Model Set-up
Refer to Figure 1-20:
The deck with gauge wheels is shipped from the factory
completely assembled to the parallel arm with the
exception of installing the rear ratchet jack and one
gauge wheel.
completely assembled to the parallel arm with the
exception of installing the rear ratchet jack and one
gauge wheel.
Ratchet Jack Installation
1.
Check 5/8" hex flange lock nuts attached to bolts (#3).
They should be drawn up snug, not tight. A-frame (#2)
should pivot freely on the two bolts.
They should be drawn up snug, not tight. A-frame (#2)
should pivot freely on the two bolts.
2.
Cut ties securing A-frame (#2) and rotate frame to
position it behind the deck as shown.
position it behind the deck as shown.
3.
Install ratchet jack (#8) to cutter deck with 1" dia.
clevis pin (#6). Secure with hair pin (#3).
clevis pin (#6). Secure with hair pin (#3).
4.
Attach opposite end of ratchet jack to A-frame (#2)
with 1" dia. clevis pin (#6). Secure with hair pin (#5).
with 1" dia. clevis pin (#6). Secure with hair pin (#5).
Gauge Wheel Set-Up
Figure 1-20
24617
Gauge Wheel Installation
1.
Install 1 1/4" I.D. machine washer (#4) over yoke
spindle (#1) as shown.
spindle (#1) as shown.
2.
Insert yoke spindle (#1) into the front support frame.
3.
Install second 1 1/4" I.D. machine washer (#4) over
yoke spindle (#1).
yoke spindle (#1).
4.
Secure yoke spindle to frame with 5/16" dia. roll
pin (#7).
pin (#7).