Braun RA200 Manuale Utente
Page 6
Parts List (ER1319):
Item Qty. Description
Part No.
1
1
Control Box - ER1301WS
100465-002
ER1301WS Installation:
Braun ER1301WS electronic controller
100465-002 is exclusive for Weight Sen-
sor ramps. Install Weight Sensor RA200
models as outlined in this section.
100465-002 is exclusive for Weight Sen-
sor ramps. Install Weight Sensor RA200
models as outlined in this section.
Installation Instructions
Installation Procedures:
1. Mount ramp assem-
bly using the eight
holes shown in Photo
C. Mounting hardware
must be minimum 7/16"
or 12mm diameter.
Position the ramp, with
top cover lip flush with
vehicle door threshold.
Level the unit front-to-
back and side-to-side.
Mounting procedures
other than those speci-
fied here must be pre-
approved by a Braun
representative.
holes shown in Photo
C. Mounting hardware
must be minimum 7/16"
or 12mm diameter.
Position the ramp, with
top cover lip flush with
vehicle door threshold.
Level the unit front-to-
back and side-to-side.
Mounting procedures
other than those speci-
fied here must be pre-
approved by a Braun
representative.
2. Route free end of
ER1317WSA harness
through vehicle floor
structure to desired
mounting location of con-
trol box.
through vehicle floor
structure to desired
mounting location of con-
trol box.
Photo C
Photo D
Ramp
Mounting
Holes
Ramp
Mounting
Holes
Ramp
Connection