ELEMENT Electronics FLX-3210 Manuale Utente
18
Chapter 2 Installing the LCD TV
Use a supplied antenna cable to connect the TV signal to the LCD TV’s TV CABLE terminal.
Connect the AC power cord at the back of the TV and connect the power cord to wall outlet.
VHF/UHF IN
HDTV/TV
Air/Cab
le
VHF/UHF IN
HDTV/TV
Air/Cab
le
BE SURE TO UNPLUG AC POWER CORD BEFORE REMOVING THE FUSE.
This TV is equipped with a safety fuse. In the event of an electrical storm or power outage
the safety fuse is designed to protect your TV. If your TV has no power, check the fuse by
prying the cover off, following the illustration below.
If the fuse is blown, visit your local hardware store and ask for a 4A 250V - 5x20mm Time
Lag Fuse (Slow Blow) to replace the fuse.
the safety fuse is designed to protect your TV. If your TV has no power, check the fuse by
prying the cover off, following the illustration below.
If the fuse is blown, visit your local hardware store and ask for a 4A 250V - 5x20mm Time
Lag Fuse (Slow Blow) to replace the fuse.
4A 250V
5x20mm
Fuse
Back of TV
Firm Plastic Prying Tool
(Using a metal tool may cause shock)
Press the button on the remote to turn on the LCD TV.
Always disconnect the LCD TV from the main power source when the LCD TV will not be used
for a long period of time. The POWER button on the front panel is only used for switching the
LCD TV into the standby mode, it does not disconnect the device from the main power
source. To completely disconnect the main power source, please remove the power cord’s
plug from the socket.
for a long period of time. The POWER button on the front panel is only used for switching the
LCD TV into the standby mode, it does not disconnect the device from the main power
source. To completely disconnect the main power source, please remove the power cord’s
plug from the socket.