3D Connexion ZT1000 Manuale Utente

zt1100/xz200 and xt1500 Series 

Removing and Replacing Parts 

51 

Troubleshooting and Self-Repair Guide 

•  Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully 

inserted. Then press down on both sides of the module until the latches snap closed. 

 

1.  Unplug the AC adapter, if present, and remove the battery. 

2.  Remove the keyboard cover (page 44). 

3.  Open the keyboard (page 48, steps 1 though 5). You don’t need to disconnect the keyboard cable. 

4.  Press outward to release the latches at the sides of the SDRAM module (so that the free edge of 

the module pops up), then pull the module out of the connector. 

 

•  Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully 

inserted. Then press down on both sides of the module until the latches snap closed.