Fujitsu P-TU4251E Manuale Utente
E-29
English
Deutsch
Espa
ñol
Fran
ç
ais
Ital
iano
Portugu
ê
s
日 本 語
Póññêèé
中文
OTHER BASIC OPERATIONS
CONVENIENT FUNCTIONS
Still Picture
Press
,
.
The currently viewed scene can be viewed as a still picture.
Convenient when you want to take a note, etc. Press again to return to the normal picture.
Convenient when you want to take a note, etc. Press again to return to the normal picture.
DISPLAY
Displaying on-screen information.
Press
3
.
The channel or mode is indicated on the screen for 5 seconds.
Picture Mode
Press
4
.
This button can be used to switch the picture mode.
In the picture mode, you can switch between the set status and the fine mode.
* For the picture mode settings, see “Setting Picture Mode (P. E-34)”.
In the picture mode, you can switch between the set status and the fine mode.
* For the picture mode settings, see “Setting Picture Mode (P. E-34)”.
Picture Memory
Press
5
.
This button can be used to recall the settings of the picture memories 1 – 8. Each time this button is
pressed, the setting changes as follows.
pressed, the setting changes as follows.
* For the picture memory settings, see “Setting Picture Memory (P. E-35)”.
Audio In
Press
6
.
Switches the input audio. Each time this button is pressed, the input changes as follows.
[When other than HDMI input was selected]
[When other than HDMI input was selected]
[For HDMI]
* Digital audio input handles PCM only.
* The digital audio input terminal on the display complies with a sampling frequency of 48 kHz.
* The digital audio input terminal on the display complies with a sampling frequency of 48 kHz.
In the case of outputs with another frequency, connect to an audio system (amplifier)*.
Dual channel switching
Press
G
.
This function enables selection of the audio mode when there is a dual-channel broadcast. Each time this
button is pressed, the mode is switched as shown in the figure below.
button is pressed, the mode is switched as shown in the figure below.
Depending on the broadcast, this function may not be available.
OFF-timer
Press
7
.
This can be used to set the time before the power is turned off (stand-by state). Each time this button is
pressed, the setting changes as follows.
pressed, the setting changes as follows.
Note
• Functions may not be available with some models and some device options.
MHD01862_E.book 29 ページ 2005年11月25日 金曜日 午後8時54分