Chicago Electric 47606 Manuale Utente

SKU 47606           

For technical questions, please call 1-800-444-3353. 

Page 2

Chuck Capacity

1 Inch

Power

120 V, 60 Hz, 1.13 HP, 850 Watts 

Amperage

6.8 Peak Amps, 4.6 Working Amps

RPM

900

Blows per minute

3,200

Accessories: Break Point (Bull) Bit, Flat Head Chisel, Depth Rod, Lubricant, 

Masonry Drill Bits (10mm, 9/16”, 7/8”), Extra Brushes, Blowmold Case

You will need the manual for the safety warnings and precautions, assembly instructions, operating 

and maintenance procedures, parts list and diagram.  Keep your invoice with this manual.  Write 

the invoice number on the inside of the front cover.  Keep the manual and invoice in a safe and 

dry place for future reference.

Keep work area clean.  Cluttered areas invite injuries.
Observe work area conditions.  Do not use machines or power tools in damp or wet locations.  

Don’t expose to rain.  Keep work area well lighted.  Do not use electrically powered tools in the 

presence of flammable gases or liquids.

Keep children away.  Children must never be allowed in the work area.  Do not let them handle 

machines, tools, or extension cords.

Store idle equipment.  When not in use, tools must be stored in a dry location to inhibit rust.  

Always lock up tools and keep out of reach of children.

use the right tool for the job.   Do not attempt to force a small tool or attachment to do the 

work of a larger industrial tool.  There are certain applications for which this tool was designed.  

It will do the job better and more safely at the rate for which it was intended.  Do not modify this 

tool and do not use this tool for a purpose for which it was not intended.

Dress properly.  Do not wear loose clothing or jewelry as they can be caught in moving parts.  

Protective, electrically nonconductive clothes and nonskid footwear are recommended when 

working.  Wear restrictive hair covering to contain long hair.

use eye, face and ear protection.  Always wear ANSI approved impact safety goggles. Wear 

a full face shield if you are producing metal filings or wood chips. Wear an ANSI approved dust 

mask or respirator when working around metal, wood, and chemical dusts and mists.

Do not overreach.  Keep proper footing and balance at all times. Do not reach over or across 

running machines.

Maintain tools with care.  Keep tools sharp and clean for better and safer performance. Follow 

instructions for lubricating and changing accessories. Inspect tool cords periodically and, if 

1.

2.

3.

4.

5.

6.

7.

8.

9.