Polar CS200 Manuale Utente
16
– ENGLISH
5. Fine-tune the positioning of both the crank magnet
and the sensor so that the magnet passes close
to the sensor without actually touching it.
and the sensor so that the magnet passes close
to the sensor without actually touching it.
The maximum distance between the cadence sensor and
the crank magnet should be 4 mm/0’16”. The gap is correct
when you can fi t a cable tie just about between the magnet
and the sensor. It is important that the lower corner of the
sensor must face the magnet when rotating, also when the
sensor has been attached to the seat tube. The lower corner
of the sensor is shown with an arrow in the picture. Once
the crank magnet and the sensor are positioned correctly,
tighten the cable ties securely and cut off any excess cable
tie ends.
the crank magnet should be 4 mm/0’16”. The gap is correct
when you can fi t a cable tie just about between the magnet
and the sensor. It is important that the lower corner of the
sensor must face the magnet when rotating, also when the
sensor has been attached to the seat tube. The lower corner
of the sensor is shown with an arrow in the picture. Once
the crank magnet and the sensor are positioned correctly,
tighten the cable ties securely and cut off any excess cable
tie ends.
5.
max 4 mm /
0’16’’
Before you start cycling, you should set the wheel size of
your bicycle into the cycling computer and turn the cadence
function on. For further information see pages 45-48.
your bicycle into the cycling computer and turn the cadence
function on. For further information see pages 45-48.