Wegener Communications 4600 Manuale Utente

22 

 800032-01 Rev. G 

www.wegener.com

Table 2.2 below lists the 

 front-panel connectors, their types and pinout 

information.

Video Monitor

BNC jack

Composite Video monitor

Audio Monitor

¼” stereo phone jack

Stereo audio headphone monitor,

selectable between audio ports 1 or 2

The 

 has one external serial port. A “device” must be assigned once to the serial 

port, but no “device” may be assigned more than once. In addition, more than one device 
may be assigned at one time but only one device which accepts input may be assigned. (If 
multiple devices are assigned to the serial port, the port’s settings are controlled by the 
device with higher priority according to the list below.) Device port assignment and device 
configuration (see below) may be controlled only from the unit front panel and the network 
may disable this capability. The possible devices are:

1.

Terminal

2.

Modem (“modem” being remote terminal via modem)

3.

Local COMPEL

®

4.

Auxiliary Data

5.

Printer (including COMPEL

®

 e-mail and reports)

When a serial port configuration command is received, the specified configuration is 
immediately stored for the specified device (e.g. for the “Terminal” device). If a serial port is 
currently assigned another device, then its output buffer is immediately flushed and the port 
re-configured. Communication is fixed at 1 start, 1 stop, and 8 data bits, with no hardware 
handshaking. No provision for software handshaking is made in this Release. The serial 
port’s behavior for each of its device types is described in the following table:

ASI IN

BNC Jack

 

DVB-ASI Input

RF IN

<plugged>

 

Not used

* LNB DC power may be locked to OFF by network.

Terminal

Configured to 19.2k, N, 8, 1. The unit responds to the terminal commands as 
described in 

on page 59.

Modem

Configured to B, P, 8, 1. The unit responds to the commands as described in 

on page 59.