Panasonic KX-TVS80 Manuale Utente
7.2
UTILITY COMMANDS
SYSTEM MAINTENANCE AND TROUBLESHOOTING
137
printer or data terminal must be connected to the VPS at the RS-232C port for the reports to be
printed or displayed.
printed or displayed.
1.
Type PSET, then Press RETURN.
2.
Type [1] to enable this function or Type [2] to disable it.
3.
Type the time to print the reports.
Note
The reports will be displayed only if the system is in the mode where the ">" prompt
is displayed.
The reports will be displayed only if the system is in the mode where the ">" prompt
is displayed.
7.2.6
Error Log Display (ELOG)
This command is used when diagnosing VPS problems. When selected, this command will
display an error log.
display an error log.
Type ELOG, then Press RETURN.
Note
The errors that can be identified by the system are displayed and explained in the following
tables.
tables.
$ PSET
Report Print Out Service [ Disable ]
1 : Enable 2: Disable :=
Report Print Out Service [ Disable ]
1 : Enable 2: Disable :=
Enter The Print Out Time (HH:MM, AM/PM) :=
COM. Communication error between CPU and DSP
DATA Process error of voice data
MEM. Memory error
PRG. Program error in CPU card
R/W Read/Write error of Flash Memory
DATA Process error of voice data
MEM. Memory error
PRG. Program error in CPU card
R/W Read/Write error of Flash Memory
$ ELOG
DEVICE ERROR TIME
DEVICE ERROR TIME
JUL-14 14:00 PM
MEM-GET
1. CPU
JUL-14 14:00 PM
2. CLOCK
JUL-14 14:00 PM
DATA R/W (xx:yyyy)
3. FLASH
MEMORY
MEMORY
JUL-14 14:00 PM
SCAN
4. DSP*
JUL-14 14:00 PM
FIFO
5. DSP*
JUL-14 14:00 PM
APPLICATION (x)
6. CPU
* = Port number (1-2)