Perreaux SXV2 Manuale Utente
25
Interconnect cables damaged
Make sure that the integrity of your interconnect cables is sound
and they are firmly connected to your turntable and the SXV2.
and they are firmly connected to your turntable and the SXV2.
SXV2 is close to external interference
Check the proximity of your SXV2 to any possible source of
EMI and/or RF interference, for example computers, televisions,
amplifiers, speakers, etc. Ideally the SXV2 should be placed as
close as possible to your turntable.
EMI and/or RF interference, for example computers, televisions,
amplifiers, speakers, etc. Ideally the SXV2 should be placed as
close as possible to your turntable.
Earth loop in system
If your preamplifier and/or amplifier have an earth/ground lift
switch, toggle it and check which setting sounds better. The
signal ground of the SXV2 is isolated from earth by default, this
means that there needs to be a connection to earth elsewhere in
your system to alleviate hum.
switch, toggle it and check which setting sounds better. The
signal ground of the SXV2 is isolated from earth by default, this
means that there needs to be a connection to earth elsewhere in
your system to alleviate hum.
My speaker
cones are
moving
excessively
at low
frequencies
Tone arm set up incorrectly
Check that your tone arm is set up correctly and it is properly
weighted and balanced.
weighted and balanced.
Turntable susceptible to vibration
Make sure that your turntable is solidly mounted on a surface that
is not prone to vibration.
is not prone to vibration.
Set RIAA curve to IEC setting
Using the IEC RIAA curve can have a similar effect to an anti-
rumble filter, by reducing the low frequency response.
rumble filter, by reducing the low frequency response.
Set DIP switch 12 on each channel to the DOWN position to
activate the IEC RIAA curve. For more information on RIAA
equalisation settings, please refer to Chapter 5.
activate the IEC RIAA curve. For more information on RIAA
equalisation settings, please refer to Chapter 5.