Mega System Tech iCV-03 Manuale Utente

Operator: 

This permission level allows the user access to 
iCAMView menus, but without the permission to amend 
them. 

Viewer: 

This permission level allows the user to access 
iCAMView at specific time as set in “Permit Hours” for 
seeing camera. The user does not have write permission 
and can only access the “Camera” and “Information” 
section. 

No Access: 

This is to revoke either of the above two permission 
levels given to a user. This disables the user account. 

 
WARNING: If you did not setup the Administrator account in Setup Wizard; you 
MUST now set an Administrator permission level BEFORE  setting either 
“Operator”, “Viewer” or “No Access”.    Failure to do so will result in you being 
locked out of iCAMView Web Manager! 
 
“IP Filter” 

Visitor can only login from the IP address specified here for security 
consideration. You can restrict a user access only from 192.168.1.0/24 by 
setting up “192.168.1.*”.    Otherwise, leave it as “*.*.*.*” to allow the user to login 
from any place. 

 

Fig.26.  iCAMView User Account Settings 

“Max FPS” 

This allows the administrator to determine the frames per second (“FPS”) 
allocated to each type of account.    By limiting the FPS, the administrator can 
manage the limited bandwidth available.  The administrator can set a figure 
between 1 to 20 and unlimited FPS. 

 

“Permit Hours” 

When the Permission level is set to either “Operator” or “Viewer”, the 
Administrator can configure and determine the time to which either permission 
level can access the camera. 

 

Click “Configure” to bring up the following window. You can set up to 4 different 
Permit Hours (in 24hr format). Click “Apply” to save and “Close” to exit.