Roland VG-99 Manuale Utente
36
Chapter 2 Creating Sounds
You can control the mix between the two channels according to how
strongly the strings are picked.
strongly the strings are picked.
1.
Press [DYNAMIC].
2.
Press PAGE [
] to display Page 1.
3.
Switch the Dynamic function on or off with
[F1] (OFF/ON).
[F1] (OFF/ON).
4.
Select the Dynamic function type.
5.
Press PAGE [
] [
] to display Page 2.
6.
Set the parameters with the F1–F5 knobs.
For detailed information on all the parameters, refer to
You can set the overall patch volume level with the PATCH LEVEL
knob. Soon after the knob is turned, the patch level settings value
pops up in the screen.
knob. Soon after the knob is turned, the patch level settings value
pops up in the screen.
*
You can also adjust this parameter in Page 2 of the Mixer screen.
fig.01-060d
You can make separate settings in each individual patch for the
overall tone after sounds have passed through the mixer.
overall tone after sounds have passed through the mixer.
1.
Press [MIXER].
2.
Press PAGE [
] [
] to display Page 3 or 4.
3.
Switch the EQ on or off with [F1] (ON/OFF) on
Page 3.
Page 3.
4.
Set the tonal quality with [F1]–[F6] or with the
F1–F6 knobs.
F1–F6 knobs.
5.
If you want to save the edited settings,
perform the Write procedure (p. 38).
perform the Write procedure (p. 38).
*
If not saving the settings, press [EXIT] to return to the Play screen.
For detailed information on all the parameters, refer to
Using Picking Dynamics to
Control the Mix Between the
Two Channels (DYNAMIC)
Control the Mix Between the
Two Channels (DYNAMIC)
Setting the Overall Patch
Volume Level (PATCH LEVEL)
Volume Level (PATCH LEVEL)
Adjusting the Overall Patch Tone
(TOTAL EQ)
(TOTAL EQ)
VG-99_e.book 36 ページ ２００７年７月５日 木曜日 午前９時２２分