Runco Q-1500d Ultra/Cinewide with Auroscope Manuale Utente
Q-1500d Series Installation/Operation Manual
13
PRE
L
IMINAR
Y
Rear Panel Layout
Figure 2-5 shows the rear connector panel on the Primary DHD Controller.
Figure 2-5. Primary DHD Controller Rear Panel
1.
MAIN POWER SWITCH
Disconnects or applies power to the DHD Controller.
Disconnects or applies power to the DHD Controller.
2.
TRIGGERS
Connection for up to three (3), 12-volt trigger-controlled devices such as retractable
screens or screen masks. Output current is limited to 250 milliamperes (mA).
Connection for up to three (3), 12-volt trigger-controlled devices such as retractable
screens or screen masks. Output current is limited to 250 milliamperes (mA).
3.
USB
A standard, USB Series “B” connection to a personal computer, for performing
software upgrades and other service procedures.
A standard, USB Series “B” connection to a personal computer, for performing
software upgrades and other service procedures.
4.
RS-232 (To Accessory Box)
A male, 9-pin D-sub connector for interfacing with the Secondary DHD Controller.
(Use a “null-modem” serial cable for this connection.)
A male, 9-pin D-sub connector for interfacing with the Secondary DHD Controller.
(Use a “null-modem” serial cable for this connection.)
5.
Display Control
Connect this to the RS-232 input on the primary (top) optical engine on the Q-1500d
projector.
Connect this to the RS-232 input on the primary (top) optical engine on the Q-1500d
projector.
6.
IR
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is a
3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is a
3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
7.
POWER INPUT (100 to 240 VAC)
Connect the DHD Controller to power here.
Connect the DHD Controller to power here.
8.
HD2 Input (5 x Analog BNCs)
Connect the HD 2 input to the Primary Analog output on the Brightness Acceleration
Engine.
The HD 1 input is not used with the Q-1500d. Connect your Component/RGBHV
sources to the Brightness Acceleration Engine.
Connect the HD 2 input to the Primary Analog output on the Brightness Acceleration
Engine.
The HD 1 input is not used with the Q-1500d. Connect your Component/RGBHV
sources to the Brightness Acceleration Engine.
9.
Video 1 Input (RCA)
Connect the Video 1 input to the Primary Composite video output on the Brightness
Acceleration Engine.
Connect the Video 1 input to the Primary Composite video output on the Brightness
Acceleration Engine.
A
B
C
D
E
H
DHD4
Primary
Do not connect any video source directly to this box.
Pr
R
Y
G
G
Pb
B
Pr
R
H
V
HD2
T
Video
Video 3
Pr
Pb
HDMI 1
HDMI 3
F
G
HDMI Out
Audio Only
HDMI Out
To Display
Ethernet
PC / Control
RS232
TRIGGERS
USB
RS-232
1
2
3
Display Control
IR
Pr
R
Pr
Pb
Video 3
G
B
R
12
8
7
6
2
5
4
3
11
14
13
1
9
10