Philips BDL4620QL Manuale Utente

BDL4620QL

18

Black dot defects appear as pixels or sub-pixels that are always dark or “off”. These are the examples of black dot defects:

One dark dot

Two adjacent dark dots = 1 pair of dark dots

Two dark dots, specifications defines the 

minimum distance between dark dots

Because pixel and sub-pixels defects of the same type that are nearby one another may be more noticeable, Philips also specifies tolerances for the 

proximity of pixel defects. In the table below you can find specifications about:

•  Allowed amount of adjacent dark dots = (adjacent dark dots =1 pair of dark dots)
•  Minimum distance between dark dots
•  Total no. of all defective dots

In order to qualify for repair due to pixel defects during the warranty period, a PDP / TFT panel in a Philips Plasma / LCD- display must have pixel or sub-

pixel defects exceeding the tolerances listed in the following table.

BRIGHT DOT EFFECT 

ACCEPTABLE LEVEL 

1 lit sub pixel 

2 

BLACK DOT EFFECT 

ACCEPTABLE LEVEL 

1 dark sub pixel 

10

TOTAL DOT DEFECTS OF ALL TYPES 

12

NOTE:   * 1 or 2 adjacent sub pixel defects = 1 dot defect

Dark spots or patches may occasionally appear on some liquid crystal display (LCD) panels. This is known within the industry as Mura, which is a Japanese 

term for “unevenness.” It is used to describe an irregular pattern or area in which uneven screen uniformity appears under certain conditions. Mura is a 

result of the deterioration of the liquid crystal alignment layer and is most commonly caused by long-term operation under high ambient temperatures.  It 

is an industry- wide phenomenon and Mura is not repairable. It is also not covered by our warranty terms.
Mura has been around since the introduction of LCD technology and with screens getting bigger and in operation 24/7, many displays are running in low 

light conditions. This all adds to the possibility of Mura affecting displays.

There are many symptoms of Mura and also multiple causes. Several of these are listed below:

•  Impurities or foreign particles in the crystal matrix
•  Uneven distribution of LCD matrix during manufacturing
•  Non-uniform luminance distribution of the backlight
•  Panel assembly induced stress
•  Flaws within the LCD cells
•  Thermal induced stress – high temperature operation over long periods of time

Although we can not guarantee the complete eradication of Mura every time, in general the appearance of Mura can be minimized by these methods:

•  Lower the backlight brightness
•  Use a screen saver
•  Reduce the ambient temperature around the unit