Cisco Systems Linksys PAP2 Manuale Utente
Prompt, Confirmation, or Message-Waiting
Encoder
Encoder in use: G711u, G711a, G726-16/24/32/40, G729a, or G729ab
Decoder
Decoder in use: G711u, G711a, G726-16/24/32/40, G729a, or G729ab
FAX
Indicate whether FAX pass-through mode has been initiated: Yes or No
Type
Indicate the call type: Inbound or Outbound
Remote Hold
Indicate whether the remote end has placed the call on hold: Yes or No
Call Back
Indicate whether the call is triggered by a call back request: Yes or No
Peer Name
Name of the peer
Peer Phone
Phone number of the peer
Duration
Duration of the call in hr/min/sec format
Packets Sent
Number of RTP packets sent
Packets Recv
Number of RTP packets received
Bytes Sent
Number of RTP bytes sent
Bytes Recv
Number of RTP bytes received
Decode Latency
Decoder latency in milliseconds
Jitter
Receiver jitter in milliseconds
Round Trip Delay
Network round trip delay (ms); available if the peer supports RTCP
Packets Lost
Total number of packets lost
Packet Error
Number of RTP packets received that are invalid
Mapped RTP Port
NAT mapped RTP port
6.2.
Enabling Logging and Debugging
The PHONE ADAPTER uses the following parameters to enable logging and debugging (both using
the syslog protocol over UDP.)
the syslog protocol over UDP.)
• Syslog_Server
• Debug_Server
• Debug_Level
• Debug_Server
• Debug_Level
6.3.
Error and Log Reporting
The PHONE ADAPTER Error Status Code (ESC) is used to indicate the current operation status of
the PHONE ADAPTER unit. An error state can be a relatively long transient state or a steady state.
The state is also represented by a special blinking pattern of the Status LED (next to the RJ-11 ports).
The Error Status Code is a 4 digit number. The first digit indicates the error class: 1xxx represents
normal operation states while 2xxx – 9xxx represent error states that must be fixed for the unit to
function properly. The status code values can be read from the IVR option XXX or from the PHONE
ADAPTER web-page.
the PHONE ADAPTER unit. An error state can be a relatively long transient state or a steady state.
The state is also represented by a special blinking pattern of the Status LED (next to the RJ-11 ports).
The Error Status Code is a 4 digit number. The first digit indicates the error class: 1xxx represents
normal operation states while 2xxx – 9xxx represent error states that must be fixed for the unit to
function properly. The status code values can be read from the IVR option XXX or from the PHONE
ADAPTER web-page.
6.4.
Internal Error Codes
The PHONE ADAPTER defines a number of internal error codes (X00–X99) to facilitate configuration
in providing finer control over the behavior of the unit under certain error conditions. They can be
viewed as extensions to the SIP response codes 100–699. The definitions are shown below
in providing finer control over the behavior of the unit under certain error conditions. They can be
viewed as extensions to the SIP response codes 100–699. The definitions are shown below
Error Code
Description
X00
Transport layer (or ICMP) error when sending a SIP request
X20
SIP request times out while waiting for a response
© 2004 Linksys Proprietary (See Copyright Notice on Page 2)
93