Kenwood TK-2170 Manuale Utente
8
I
NSTALLING
/ R
EMOVING
A
LKALINE
B
ATTERIES
◆ Do not install batteries in a hazardous environment where sparks
could cause an explosion.
◆ Never discard batteries in fire; extremely high temperatures can
cause batteries to explode.
◆ Do not short circuit the battery case terminals.
◆ Do not use rechargeable batteries.
Note:
◆ If you do not plan to use the transceiver for a long period, remove
◆ If you do not plan to use the transceiver for a long period, remove
the batteries from the battery case.
◆ This battery case has been designed for transmitting at a power
of approximately 1 W (the low power setting on your transceiver).
If you want to transmit a stronger signal (using the high power
setting on your transceiver), use an optional rechargeable battery
pack.
If you want to transmit a stronger signal (using the high power
setting on your transceiver), use an optional rechargeable battery
pack.
1
To open the battery case,
press on the two tabs on the
upper rear of the case, then
pull the two halvs apart.
press on the two tabs on the
upper rear of the case, then
pull the two halvs apart.
2
Insert 6 AA (LR6) Alkaline
batteries into the battery case.
batteries into the battery case.
•
Be sure to match the polarities
with those marked in the
bottom of the battery case.
with those marked in the
bottom of the battery case.
3
Align the tabs of the cover
with the base, then push down
on the cover until it locks in
place.
with the base, then push down
on the cover until it locks in
place.