2nd Ave. C62 Dépliant
1
Remove everything from the box.
2
Remove the tape and
packing material.
packing material.
3
Peel off the tape beneath the cover
and remove the insert.
and remove the insert.
4
Slide the paper support into
its three slots on the back
of the printer.
its three slots on the back
of the printer.
1
1
Unpack
Unpack
Turn On the Printer
Turn On the Printer
1
Plug the printer’s power cord into a grounded electrical outlet. (Don’t turn on
your computer yet.)
your computer yet.)
2
Press the
power button to turn it on.
Install Ink Cartridges
Install Ink Cartridges
1
Open the output tray.
2
Open the printer cover.
3
Lift up both ink cartridge clamps.
4
Unpack the ink cartridges that came
with your printer and remove the
yellow tape from the top.
with your printer and remove the
yellow tape from the top.
5
Lower each cartridge down into the holder.
Make sure the tabs rest on the hooks
in the back.
in the back.
6
Shut the clamps and make sure they
click into place.
click into place.
7
Close the printer cover.
8
Press the
Ink Cartridge Replacement button.
The green
power light flashes as your printer
charges ink for about 1
1
/
2
minutes.
CAUTION: Don’t turn off the printer or
interrupt charging while the
interrupt charging while the
power light
is flashing or you’ll waste ink.
Load Paper
Load Paper
1
Load some paper behind the tabs inside the edge guides.
2
Press in the locking tab on the
left edge guide and slide it to fit
lightly against the paper stack.
left edge guide and slide it to fit
lightly against the paper stack.
3
Pull out the output tray extension.
Turn over
Printer connection cables are not included with your printer.
You need
You need
only one of the following cables:
• USB cable (PC or Mac)
or
• Parallel cable (PC only).
USB Cable Users
1
Shut down your computer. In Windows
®
, click
Start and select the Shut Down
or
Turn Off option.
2
Plug the flat end of the USB cable into any available USB port on your computer.
3
Plug the square end of the cable into your printer’s USB port.
Parallel Cable Users
1
Shut down your computer. Click
Start and select the Shut Down or Turn Off option.
2
Plug the end of the cable with the screws on the side into your computer’s parallel port
and secure it.
and secure it.
3
Plug the end of the cable with the slotted connector into your printer’s parallel port,
then secure it with the wire clips.
then secure it with the wire clips.
2
2
Connect the Printer
Connect the Printer
Printer
Paper
support
Ink cartridges
Printer Basics
Printer Software
CD-ROM
Output tray
Printer cover
Power cord
EPSON Stylus C62
Start
Here
Here
Start
Here
Here
EPSON Stylus
®
C62
CPD-14476
4031970-00
3
3
4
4
5
5