Shoprider GK8 Manuale Utente

 

3/17/2005 

11

 
The drive/freewheel lever (yellow ball handle) is located under the seat at the right rear of 
unit.  This lever allows you to disengage the drive mechanism and push the scooter while in 
freewheel mode. To disengage the drive mechanism (neutral), move the lever forward (the 
scooter can now be pushed).  To re-engage the drive mechanism (drive), move the lever 
backward (now the unit may be driven). 
Note: The scooter will not operate while the drive/freewheel lever is in the neutral position 
(forward). The scooter must be turned off, lever moved backward (drive position) and then 
turned on in order to reset the circuits.  

 
WARNING! Always re-engage the free wheeling device after use. Failure to do so 
may result in injury. 

 
Anti-tip wheels 
The anti-tip wheels are located at the rear of the scooter frame (Fig 8).  The scooter should 
not be used unless the anti-tipping wheels are in place. 
 
Shoprider® is not responsible for damage or injury incurred due to improper or 
misuse of the scooter. 
 
Scooter serial number 
The scooter serial number is located on the seat post and consists of a combination of 13 
numbers and letters. Shoprider recommends that you write the serial number down on the 
back of this manual for future reference. Refer to Page 8, Fig 5. 
 
 
 
 
 
 
 
 
 
 
 
 

Figure 8 

Free Wheel 
Lever (yellow)

 

Anti-Tip Wheels

Push Scooter 

 Drive Scooter 

Charging Port

 

Circuit Breaker 
(Reset Button) 

Detach Lever 
(yellow)