Shoprider 858WM Manuale Utente

3/28/2008

6Runner 888WNLM,858WM, 888WNLLHD
How to Charge Your Unit

1) Plug the A/C power cord into the wall. Plug the male three-pin

charger plug into the female 3-pin receiver located on the
bottom of the VSI. Turn the switch on if applicable (8Amp
charger only)

The battery charger’s light indicator is as follows:
One light charger (4Amp)
Yellow/Amber- Charging
Green- Charging

Complete

Or
Two light charger (8Amp)
Red (solid)-

Power ON

Yellow/Amber- Charging
Green- Charged
NOTE: It is very important to check the charger light color. If there is
no light or a different color light on than should be, refer to the
charging trouble shooting section in this manual.
Depending on the amount of battery discharge, the charge time can
take up to 12 hours. The battery charger has an electronic switch that
will terminate the charge when the batteries are fully charged. Do not
remove the battery charger until the charging cycle is complete. Be
sure to unplug charger from the wall first before unplugging charger
from the Powerchair.

WARNING! Only use the original manufacturer approved
charger!
This charger is for indoor use only. Do not expose it to rain or
water spray.
Do not leave the charger plugged into the Charging Port if the
charger is not charging.