SonicWALL 5.8.1 Manuale Utente

If you are using PPPoE, a Client Settings section displays in the Protocol tab:

If you want PPPoE to disconnect after a specific time period, Click the Inactivity Disconnect 
checkbox and enter the time period (in minutes).

If you want to use LCP echo packets for server keep-alive, click the Strictly use LCP echo 
packets for server keep-alive checkbox.

If you want the PPPoE client to reconnect to the server when traffic is not sent for a specific 
time period, enter the time period (in minutes) in the text field. This checkbox is selected by 
default.

Click the OK button

The SonicWALL NSA 2400MX and NSA 250M security appliances support the following 
optional NSA Expansion Pack modules:

1-Port ADSL (RJ-11) Annex A module

1-Port ADSL (RJ-45) Annex B module

1-Port T1/E1 module

2-Port LAN Bypass module

2-Port SFP module

4-Port Gigabit Ethernet module (SonicWALL NSA 2400MX)

4-Port Gigabit Ethernet module (SonicWALL NSA 250M series)

These interfaces are listed in the Interface Settings table as the Mx interfaces. 

Before attempting to insert and configure the module, you must power off the appliance. 
Once the appliance has been powered down, remove the rear module plate cover and insert 
the expansion module.Tighten the screws to secure the module, then power on the 
appliance. 

Log into the SonicWALL management interface. You can now begin configuring the desired 
expansion module. The following sections describe how to configure the