SonicWALL 5.8.1 Manuale Utente
Network > PortShield Groups
269
SonicOS 5.8.1 Administrator Guide
Note
Make sure the IP address you assign to the PortShield interface is within the WAN
subnetwork.
subnetwork.
When you create a PortShield interface in Transparent Mode, you create a range of addresses
to be applied to the PortShield interface. You include these addresses in one entity called an
Address Object. Address Objects allow for entities to be defined one time and to be re-used in
multiple referential instances throughout the SonicOS interface. When you create a PortShield
interface using an address object, all ports mapped to the interface are identified by any of the
addresses specified in the address range.
to be applied to the PortShield interface. You include these addresses in one entity called an
Address Object. Address Objects allow for entities to be defined one time and to be re-used in
multiple referential instances throughout the SonicOS interface. When you create a PortShield
interface using an address object, all ports mapped to the interface are identified by any of the
addresses specified in the address range.
Note
Each statically addressed PortShield interface must be on a unique subnetwork. You can
not overlap PortShield interfaces across multiple subnetworks.
not overlap PortShield interfaces across multiple subnetworks.
Configuring PortShield Groups
There are several ways to configure PortShield groups:
•
•
•
Configuring PortShield Interfaces from the Network > Interfaces Page
To configure a PortShield interface, perform the following steps:
1.
Click on the Network > Interfaces page.