SonicWALL 5.8.1 Manuale Utente

The Station Status table displays information about wireless connections associated with the 
wireless security appliance. 

Station - the name of the connection used by the MAC address

MAC Address - the wireless network card MAC address

Authenticated - status of wireless authentication

Associated - status of wireless association

AID - Association ID, assigned by the security appliance

Signal - strength of the radio signal

Timeout - number of seconds left on the session

Configure - options for configuring the station:

 -configure power management on the wireless network card of this station, if 

enabled. 

 - block the station from the security appliance and add it to the Deny MAC Filter List.

 - dissociate the station from the security appliance.

The Discovered Access Points table appears when the SonicWALL appliance is in Wireless 
Client Bridge mode.

To create a wireless bridge with another access point:

Before you begin, verify that your wireless security settings match that of the access point 
to which you are bridging, and that you have switched your SonicWALL TZ wireless 
appliance to Wireless Client Bridge mode in the Wireless > Settings page.

In the Wireless > Status screen, locate the access point you wish to bridge to and click the 
Connect button.

The configuration is set and your SSID changes to mirror that of the wireless bridge host.

For security reasons, never create a bridge over an open wireless connection.