SonicWALL 5.8.1 Manuale Utente

Egress - The SonicWALL appliance interface on which the packet was captured when sent 
out

The subsystem type abbreviation is shown in parentheses. See the table above for 
definitions of subsystem type abbreviations

Source IP - The source IP address of the packet

Destination IP - The destination IP address of the packet

Ether Type - The Ethernet type of the packet from its Ethernet header

Packet Type - The type of the packet depending on the Ethernet type; for example: 

For IP packets, the packet type might be TCP, UDP, or another protocol that runs over 
IP

For PPPoE packets, the packet type might be PPPoE Discovery or PPPoE Session

For ARP packets, the packet type might be Request or Reply

Ports [Src, Dst] - The source and destination TCP or UDP ports of the packet

Status - The status field for the packet

The status field shows the state of the packet with respect to the firewall. A packet can be 
dropped, generated, consumed or forwarded by the SonicWALL appliance. You can 
position the mouse pointer over dropped or consumed packets to show the following 
information.

Length [Actual] - Length value is the number of bytes captured in the buffer for this packet. 
Actual value, in brackets, is the number of bytes transmitted in the packet.

Dropped

Module-ID = <integer>

Value for the protocol subsystem ID

Drop-code = <integer>

Reason for dropping the packet

Reference-ID: <code>

SonicWALL-specific data

Consumed

Module-ID = <integer>

Value for the protocol subsystem ID