Multiquip MQD2H Manuale Utente

„ NEVER let power cords or cables lay in water.

„ NEVER use damaged or worn cables or cords. Inspect 

for cuts in the insulation. 

„ NEVER grab or touch a live power 

cord or cable with wet hands. The 
possibility exists of electrical shock, 
electrocution or death. 

 

„ Make sure power cables are securely connected to the 

motor's output receptacles. Incorrect connections may 
cause electrical shock and damage to the motor.

„ NEVER attempt to use the power cord as a lifting or 

lowering device for the pump.

„ ALWAYS make certain that proper power or extension 

cord has been selected for the job. See Cable Selection 
Chart in this manual.

„ ALWAYS make sure pump is grounded.

„ ALWAYS make sure that electrical circuits are properly 

grounded to a suitable earth ground (ground rod) per 
the National Electrical Code (NEC) and local codes 
before operating generator. Severe injury or death by 
electrocution can result from operating an ungrounded 
motor.

„ NEVER use gas piping as an electrical ground.

 

„ When raising or lowering of the pump is required, always

attach an adequate rope or lifting device to the correct 
lifting point (handle) on the pump.

„ DO NOT lift machine to unnecessary heights.

„ NEVER lift the equipment while the engine is running.

„ ALWAYS shutdown pump before transporting.

„ ALWAYS tie down equipment during transport by

securing the equipment with rope.

 

„ Dispose of hazardous waste properly. 

Examples of potentially hazardous waste 
are used motor oil, fuel and fuel filters.

„ DO NOT use food or plastic containers to dispose of 

hazardous waste.

„ DO NOT pour waste, oil or fuel directly onto the ground, 

down a drain or into any water source.