KTI Networks KC-300DM Dépliant
Product Highlights :
Full wire speed performance
Comprehensive configuration
options
Loop back test support
Remote TP link monitoring
Low power consumption
Loop back test support
Optional Din-Rail mounting
Center Chassis installation
support
Options for Bi-Di
communication
Options for CWDM
KC-3DR :
Din-Rail mounting bracket
Din-Rail mounting bracket
KC-1300 :
Managed center chassis
Managed center chassis
Specifications :
10/100Base-TX to 100Base-FX
Media Converters
The media converters are designed to convert 10Base-T or 100Base-T signals to/from 100Base-FX
fiber signals. It is used to extend the connection distance between two Ethernet devices via fiber
cable transparently with no performance degradation. The media converters not only support
existing variety of multimode and single mode fibers but also support Bi-Di WDM and CWDM fiber
network applications. It is also featured with design to support center chassis installation with
optional power redundancy and management features when a larger fiber network is required.
fiber signals. It is used to extend the connection distance between two Ethernet devices via fiber
cable transparently with no performance degradation. The media converters not only support
existing variety of multimode and single mode fibers but also support Bi-Di WDM and CWDM fiber
network applications. It is also featured with design to support center chassis installation with
optional power redundancy and management features when a larger fiber network is required.
Key Features :
Convert speed and media type in full wire speed
Support 10/100M dual speed on TP connections, auto-negotiation, and auto-MDI/MDI-X
detection
Link fault pass through function
Transparent to 802.1Q VLAN tagged packets
Far End Fault function on FX port
Support desktop,wall, and DIN-rail mounting
Support center chassis installation
Low power consumption
Support wide range of fiber options
Provide user accessible settings for TP port configuration,disabling link fault pass through
function
KC-300DM Specific
Provides indications of remote media converter's TP port status
Provides Loop Back Test function with connected remote media converter
TP Port
IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX
Shielded RJ-45 jacks with Auto MDI/MDI-X detection
Auto-negotiation for speed and duplex auto detection
Forced mode with speed and duplex settings
Speed for 10Mbps or 100Mbps, Full-duplex or half-duplex support
FX Port
IEEE 802.3u 100Base-FX compliant
Forced 100Mbps, Full duplex (factory default)
Far end fault Function
Cable
Cat. 5 UTP cable, MMF - 62.5/125µm, 50/125µm, SMF - 9 /125µm
LEDs
KC-300D :
Power status
TP Ports :
Link/Act, Speed, Duplex status
FX Ports :
Link/Act status, Fiber signal detected
KC-300DM:
Power status
TP Ports :
Link/Act, Speed, Duplex status
FX Ports :
Link/Act status, Fiber signal detected
Remote TP Ports : Link, Speed, Duplex status
KC-300D, KC-300DM
080110