Manuale UtenteSommarioUnited States FCC, Part 1513Installing TAD13Assembling13Parts13To assemble the TAD unit141. Insert the battery into the battery well.142. Place the battery hatch inside the battery well. Using a screwdriver, rotate the battery hatch clockwise until the battery is secure.143. Slide the battery cover over the battery hatch.144. Slide the fixed strap into the fiber-optic connection bay opposite of the charging port.145. Slide the adjustable strap into the other fiber-optic connection bay.146. Using a Phillips screwdriver, secure the straps between the unit case and the strap clamps with the provided screws. Place one screw into each hole, and rotate each screw clockwise until you feel resistance.147. Assemble the joint of the male and female hinges using the joint pin. Slide the joint pin through the hinge loops until the joint pin is flush with the hinge assembly.14Sizing14To size the TAD unit141. Wrap the adjustable strap around the client’s ankle and inside the fixed strap.142. Wrap the fixed strap around the client’s ankle and on top of the adjustable strap.143. Note the sizing number on the adjustable strap that is closest to the fixed strap. For an accurate strap measurement, the absorption sensor must be firmly pressed against the client’s ankle with a 50% depression into the absorption sensor cavity.144. Remove the unit from the client’s ankle.145. Slide the male hinge into the sizing hole numbered three more than the number you noted in step 3. For example, if you noted the strap sizing number 6 in step 3, you will slide the male hinge into the strap hole numbered 9.15Attaching15To attach the TAD unit151. Wrap the TAD unit around the client’s ankle as you did in step 1 of the previous section.152. Align the male hinge with the fiber-optic connector on the fixed strap. Press firmly on the fixed strap to hold both straps in place.153. Close the hinge assembly around the straps until the locking holes are aligned.154. Slide a locking pin into both sides of the hinge assembly. The wing-tipped ends of the locking pins must be inserted first. The locking pins should be flush with the sides of the hinge assembly.15Installing the HomeBase161. Place the HomeBase receiver in the selected location.162. Plug the round connector of the power cord into the back of the receiver and plug the other end into the wall socket.163. Insert one end of the supplied phone cord into the wall jack and the other end into one of the phone jacks on the back of the...164. Use your officer key to turn the receiver power switch to the ON position.16Dimensioni: 407 KBPagine: 16Language: EnglishApri il manuale