Manuale UtenteSommarioBEFORE YOU BEGIN...................................................................................... 12IMPORTANT SAFETY NOTICES..................................................................... 22HARDWARE IDENTIFIER.....…....................................................................... 42ASSEMBLY INSTRUCTIONS........................................................................... 52EXPLODED DIAGRAM……………………………………………………………… 92PARTS LIST...................................................................................................... 102WARRANTY.................................................................................................…. 112ORDERING PARTS.......................................................................................… 112WARNING LABEL REPLACEMENT4HARDWARE PACK5ASSEMBLY INSTRUCTION6Attach a Diagonal Support (#4) to the Lower Upright Beam (#5) and the Right Base Frame (#2). Secure it to the Lower Upright Beam with two M10 x 3” Carriage Bolts (#20), Ø 1 ¼” Bent Washers (#22), and M10 Aircraft Nuts (#18). Secure it to the Right Base F7Attach a Dip Support (#9) to the Lower Upright Beam. Align the holes and secure them with two M10 x 3 1/8” Carriage Bolts (#21), one Curve Bracket (#11), and two M10 Aircraft Nuts (#18). Repeat the same stop to install the other side.7Attach two Upper Upright Beams (#6) onto the Lower Upright Beams (#5).7Connect the two Upright Beams with a Cross Brace (#7) in the middle. Secure each side with two M10 x 3” Carriage Bolts (#20), ( 1 ¼” Bent Washers (#22) and M10 Aircraft Nuts (#18). Do NOT tighten all the Nuts and Bolts yet.7Attach a Vertical Handle (#8) to the Dip Support. Secure it with one M10 x 1” Allen Bolt (#31) and Ø ¾” Bent Washer (#24). Repeat to install the other side.7DIAGRAM 28STEP 3 (See Diagram 3)9Attach the Chin-up Bar (#10) to the top opening on the two Upper Upright Beams. Secure the Chin-up Bar to each opening with one M8 x 1 5/8” Allen Bolt (#27) and Ø ½” Bent Washer (#34). Cover each opening with an Upright Beam End Cap (#30).9Attach the two Arm Pads (#15) onto the Dip Supports. Secure each Arm Pad with two M8 x 2 ½” Allen Bolts (#16) and Ø 5/8” Bent Washers (#26).9Attach the Backrest Board (#14) to the Cross Brace (#7). Secure it with two M8 x ¾” Allen Bolts (#29) and Ø 5/8” Washers (#28).9Securely tighten all Nuts and Bolts previously installed.9EXPLODED DIAGRAM10Parts list11KEY NO. DESCRIPTION Q’ty11Dimensioni: 1,22 MBPagine: 12Language: EnglishApri il manuale