Manuali utente per Impex TC-3508

Sommario

• BEFORE YOU BEGIN...................................................................................... 1

  2
• IMPORTANT SAFETY NOTICES..................................................................... 2

  2
• HARDWARE IDENTIFIER.....…....................................................................... 4

  2
• ASSEMBLY INSTRUCTIONS........................................................................... 5

  2
• EXPLODED DIAGRAM……………………………………………………………… 9

  2
• PARTS LIST...................................................................................................... 10

  2
• WARRANTY.................................................................................................…. 11

  2
• ORDERING PARTS.......................................................................................… 11

  2
  • IMPORTANT SAFETY NOTICE

    3
• HARDWARE PACK

  5
• ASSEMBLY INSTRUCTION

  6
  • A.) Attach the Upper Vertical Frame (#1) onto the Lower Vertical Frame (#2). Secure it with two L-shaped Brackets (#9), two M10 x 3” Carriage Bolts (#31) from the front, two M10 x 3 5/8” Carriage Bolts (#30) from the side, four ( ¾” Washers (#35), and four M10 Aircraft Nuts (#33).

    7
  • B.) Attach the Chin-up Bar (#3) to the front of Upper Vertical Frame. Secure it with two M10 x 2” Allen Bolts (#25) and ( ¾” Washers (#35). Cover the Bolts with a 2” x 2 ¾” Plastic Cover (#16).

    7
  • STEP 3 (See Diagram 3)

    8
  • A.) Attach the Left & Right Dip Supports (#7 & #8) to the Upper Vertical Frame (#1). Secure them to the Upper Vertical Frame with one M12 x 3 ¾” Allan Bolt (#26), two ( ¾” Washers (#37), and one M10 Aircraft Nut (#34). Do NOT over tighten the nut and bolt. Make sure the arms are able to move freely.

    8
  • C.) Insert a Vertical Handle (#13) into the hole on each Dip Support. Secure each Handle with one M10 x 1” Allen Bolt (#27) and Ø ¾” Curved Washer (#38).

    8
  • STEP 4 (See Diagram 4)

    9
  • A.) Attach the Backrest Pad (#12) to the Upper Vertical Frame (#1). Secure it with two M8 x 2 ¾” Allen Bolts (#28) and ( 5/8” Washers (#36).

    9
  • B.) Attach the Arm Pads (#11) to the Left & Right Dip Supports (#7 & #8). Secure each Arm Pad with two M8 x 2 ¾” Allen Bolts (#28) and Ø 5/8” Curved Washers (#39).

    9
• EXPLODED DIAGRAM

  10
• Parts list

  11
• KEY NO. DESCRIPTION Q’ty

  11
  • 16 2” x 2 ¾” Plastic Cover 1

    11