Manuali utente per Impex WM-357

Sommario

• BEFORE YOU BEGIN...................................................................................…. 1

  2
• IMPORTANT SAFETY NOTICES..................................................................…. 2

  2
• HARDWARE IDENTIFIER.....…....................................................................…. 4

  2
• ASSEMBLY INSTRUCTIONS........................................................................…. 5

  2
• EXPLODED DIAGRAM………………………………………………………………. 10

  2
• PARTS LIST...............................................................................................……. 11

  2
• WARRANTY.................................................................................................…. 12

  2
• ORDERING PARTS.......................................................................................… 12

  2
• ASSEMBLY INSTRUCTION

  6
  • Attach the Leg Developer (#7) to the Front Leg (#5). Secure it with one M8 x 3 1/8” Allen Bolt (#39), two Ø 5/8” Washers (#44), and one M8 Aircraft Nut (#49).

    8
  • Insert two Foam Tubes (#13) halfway through the holes on the Leg Developer. Push four Foam Rolls (#30) onto the Tubes from both sides.

    8
  • Place a Spring Clip (#26) onto the weight post on the Leg Developer. The maximum weight capacity for Leg Developer is 100 lbs.

    8
  • Attach the Backrest Supports (#12) onto both ends of the pivot on the Main Seat Support (#3). Place the other end rest against the Backrest Adjustment Bar (#35).

    9
  • Place the Backrest Board (#34) onto the Backrest Supports. Secure it with four M6 x 1 ½” Hex Bolts (#41) and Ø ½” Washers (#45).

    9
  • Place the Seat Pad (#33) onto the Main Seat Support. Secure it with four M6 x 1 ½” Hex Bolts (#41) and Ø ½” Washers (#45).

    9
    • DIAGRAM 4

      9
  • Attach the Arm Curl Pad (#32) to the Arm Curl Stand (#6). Secure it with two M8 x 5/8” Allen Bolts (#38) and Ø 5/8” Washers (#44).

    10
  • Insert the Arm Curl Stand into the top opening on the Front Leg. Secure it with a Lock Knob (#16).

    10
    • DIAGRAM 5

      10
  • 1 Right Upright Beam 1

    12
  • 19 Ø 1 ½” Bushing 2

    12
  • 20 2 3/8” Rubber Bumper 2

    12
  • 21 Ø 1 ¼” Bushing 2

    12