Manuali utente per Maretron M001101

Sommario

• General

  1
• 1.1 Introduction

  1
• 1.2 Firmware Revision

  1
• 1.3 Features

  1
• 1.4 Quick Install

  1
• 2.1 Unpacking the Box

  2
• 2.2 Choosing a Mounting Location

  2
• 2.2.1 Mounting Location When Used With Analog Gauge(s)

  2
• 2.2.2 Mounting Location When Used Without Analog Gauge(s)

  3
• Figure 1– Mounting Location When Used with Analog Gauge

  3
• 2.3 Connecting the RAA100

  4
• 2.3.1 Connecting Attached Gray Cable to Analog Gauge or Rudder Sender

  4
• Figure 2 – Mounting Location When Used Without Analog Gauge

  4
• Figure 3 – RAA100 Connections

  4
• 2.3.1.1 Connecting Attached Gray Cable to Analog Gauge

  5
• 2.3.1.2 Connecting Attached Gray Cable to Rudder Angle Sender

  5
• 2.3.2 Connecting to NMEA 2000® Interface

  5
• Table 1 – RAA100 Gauge Connections

  5
• Table 2 – RAA100 Resistive Rudder Angle Sender Connections

  5
• 3.1 Configuring Rudder Instance Number

  6
• Figure 4 – NMEA 2000® Connector Face Views

  6
• 3.2 Configuring Operating Mode

  7
• 3.2.1 Configuring Analog Gauge Resistance

  7
• 3.2.1.1 Power Terminal to Sensor Terminal Resistance Measurement

  7
• 3.2.1.2 Ground Terminal to Sensor Terminal Resistance Measurement

  7
• 3.3 Standard Sender Selection or Custom Calibration

  8
• 3.3.1 Standard Sender Selection

  8
• 3.3.2 Custom Calibration

  8
• Troubleshooting

  9
• Figure 5 – Troubleshooting Guide

  10
• Technical Support

  11