Manuali utente per Motion Computing 002-15-0010

Sommario

• BASE WITH POWER SUPPLY SHROUD INSTALLED

  1
• REMOVE THE PLASTIC SHROUD THAT COVERS THE POWER SUPPLY

  1
• COLUMN ASSEMBLY

  1
• 2.1 LAY BASE ON ITS BACK

  2
• 2.2 POSITION COLUMN ABOVE BASE

  2
• TIGHTENING ANY BOLT. TIGHTEN ALL FOUR BOLTS.

  3
• 2.4 SET CART UPRIGHT

  3
• 2.5 REMOVE ONE SCREW AND LOOSEN THE OTHER SCREW OF THE COLUMN TOP PLATE

  4
• 2.6 INSERT DECORATIVE COVER IN THE BACK OF THE COLUMN CHANNEL GROVES.

  4
• 2.7 SLIDE DECORATIVE COVER DOWN TO WITHIN 24 INCHES OF THE BASE

  4
• 2.8 ROUTE CABLES BEHIND THE DECORATIVE COVER

  5
• 2.9 SLIDE DECORATIVE COVER TO THE BOTTOM OF THE COLUMN

  5
• GROVES

  5
• 2.11 SLIDE THE DECORATIVE COVER DOWN SO IT TOUCHES THE FIRST COVER

  6
• INSTALLING THE WORK SURFACE AND DRAWER

  6
• RAILS

  6
• NOTE WHERE THE ALLEN SET SCREWS ARE LOCATED

  7
• ON THE FRONT COLUMN

  7
• BOTTOM OF THE RAIL.

  7
• TIGHTEN THE SET SCREWS

  8
• FULLY TIGHTEN THE SET SCREWS

  8
• REINSTALL THE DRAWER BY SLIDING IT ONTO THE DRAWER RAILS

  9
• ASSEMBLE THE CPU/MONITOR VESA MOUNT ASSEMBLY

  10
• ATTACH METAL SPACERS TO THE FRONT CPU VESA MOUNT PLATE CORNERS

  10
• INDICATE

  10
• THREADING THEM INTO THE MONITOR VESA MOUNT PLATE THREADED INSERTS

  11
• ATTACH THE FLUSH TILTING VESA MOUNT BRACKET TO THE BACK CPU VESA MOUNT PLATE

  11
• BETWEEN THE METAL SPACERS AND CONNECTORS FACING DOWN

  11
• THREADED METAL SPACERS ATTACHED TO THE FRONT PLATE

  12
• MOUNT BRACKET INTO THE FRONT OF THE COLUMN RAIL

  12
• BY TIGHTENING THE SET SCREWS

  13
• ASSEMBLE THE BATTERY GAUGE HOUSING

  13
• ASSEMBLE THE MOUNTING PLATE AND BATTERY GAUGE

  13
• THE FIXED MOUNT SCREWS.

  14
• ATTACH THE BATTERY GAUGE HOUSING TO THE MOUNTING PLATE.

  14
• THE BATTERY GAUGE, AND ADHERE THE BATTERY GAUGE TO THE MOUNTING PLATE ASSEMBLY.

  15
• BACK OF THE BATTERY GAUGE HOUSING.

  16
• PLUG IN AND SECURE MONITOR CABLES

  18
• PLUG IN AND SECURE COMPUTER CABLES

  18
• SECURING WITH CABLE TIES.

  19
• PULL THE EXCESS CABLE LENGTH TO THE BOTTOM OF THE COLUMN

  19
• THE SHEET METAL BASE.

  20
• IN, THE THERMAL SENSORS WILL READ INCORRECTLY.

  21
• BATTERY POST.

  22
• MAKE SURE BATTERY CONNECTIONS ARE TIGHT ON BOTH BATTERIES

  22
• REINSTALL THE SHROUD AND COLUMN TOP PLATE

  23