Manuale UtenteSommarioProduct Summary1The SX-V to Learn Mode Translator receives RF signals from SX-V sensors and converts them to Lear...1Tools and Equipment Needed1Installation1Installation Guidelines1Mounting the Translator11. Remove the translator cover and set it aside.12. Place the translator on the wall at the desired location and mark the three mounting hole loca...13. Install anchors where studs are not present.14. Place the translator on the wall at the marked locations and secure it using the included screws.1Wiring the Translator11. Run a 2-conductor, 22-gauge or larger stranded wire cable from the control panel or power supp...12. At the translator, connect the red wire to the +12V terminal and the black wire to the GND ter...1Figure 2. Translator Power Wiring Connections13. Make sure the power source (control panel or separate power supply) is powered down.14. Connect the red and black wires to the +12 and GND (-) terminals of the power source.1Setting the Translator House Code1Figure 3. Binary Values of Switches1Power Up1Programming1Adding the Translator to the Panel21. Set the control panel to program mode.22. Select the desired sensor number and sensor group when prompted by the panel.23. When prompted by the panel to trip the sensor, press and hold the translator tamper switch for...24. Exit from program mode.2Adding SX-V Sensors to the Panel21. Set the control panel to program mode.22. Select the desired sensor number and sensor group when prompted by the panel.23. When prompted by the panel to trip the sensor, press and release the sensor tamper switch, tes...24. Repeat steps 2 and 3 for all sensors/touchpads.25. Exit from program mode.2Testing2Specifications2Notices2FCC Part 15 Class B2Dimensioni: 64,1 KBPagine: 4Language: EnglishApri il manuale
