3M 78-8135-4385-3-A ユーザーズマニュアル
78-8135-4385-3-A
15
14.3 Using the die labeled “A” with the 3M lettering facing
to the left, crimp the metal portion of the sleeve once.
Note: Crimp sleeve must be bottomed against connector
prior to crimping. The 3M lettered side of the crimp die
should be touching the rear of the connector.
14.4 Place the crimp/shrink tube in the shrink fixture
assembly and heat for 8 to 10 seconds. Tube should
shrink snug around the jacket. Rotate, if needed, to
complete shrink.
14.5 Slide boot over crimp/shrink tube.
Note: Jacketed boots appear the same in the photos but the
Note: Jacketed boots appear the same in the photos but the
boots for all 3 types of connectors are different sizes and
can not be interchanged.