Precor 303135-111 ユーザーズマニュアル

ページ / 152
8
 
Operating and Maintaining the P80 Console 
 
 
 
SPACING—The below minimum spacing 
recommendations are based on a combination of the 
ASTM (U.S.) voluntary standards and EN (European) 
regulations as of October 1, 2012, for access, passage 
around, and emergency dismount: 
– 
Treadmills—a minimum of 0.5 m (19.7 in.) on each 
side of the treadmill and 2 m (78 in.) behind the 
machine. 
– 
Cardio equipment other than treadmills—
minimum of 0.5 m (19.7 in.) on at least one side, and 
0.5 m (19.7 in.) behind or in front the machine. 
Careful consideration should be given to the 
requirements of the Americans with Disabilities Act 
(ADA), US Code 28 CFR (see Section 305). ASTM 
standards are voluntary and may not reflect current 
industry standards. The actual area for access, passage 
around, and emergency dismount is the responsibility of 
the facility. The facility should consider the total space 
requirements for training on each unit, voluntary and 
industry standards, and any local, state, and federal 
regulations. Standards and regulations are subject to 
change at any time. 
Important: These spacing recommendations should be used 
when positioning equipment away from sources of heat, such 
as radiators, heat registers, and stoves. Avoid temperature 
extremes. 
 
Keep equipment away from water and moisture. Avoid 
dropping anything on or spilling anything inside the 
equipment to prevent electric shock or damage to the 
electronics.   
 
When using the treadmill, always attach the safety clip to 
your clothing before beginning your workout. Failure to 
use the safety clip may pose a greater risk of injury in the 
event of a fall. 
 
Keep in mind that heart rate monitors are not medical 
devices. Various factors, including the user’s movement, 
may affect the accuracy of the heart rate readings. The 
heart rate monitors are intended only as exercise aids in 
determining heart rate trends in general. 
 
Do not operate electrically powered equipment in damp 
or wet locations. 
 
Never operate this equipment if it has a damaged cord or 
plug, if it is not working properly, or if it has been dropped, 
damaged, or exposed to water. Call for service 
immediately if any of these conditions exist.