Precor 5.33 ユーザーズマニュアル

The EFX can display measurements in either U.S. Standard 
(U.S. STD) or METRIC. The default factory setting is set to 
display U.S. STD. To change this setting, perform the 
following steps:

1. At the Precor banner, press the following keys in 

sequence and without pause: 

RESET, QUICKSTART, ENTER, SELECT [USER 2], 
CROSSRAMP 

▲

 

Note: No CROSSRAMP keys exist on the EFX5.33. Use 
the RESISTANCE 

▲

 key on the left side of the keypad.

As shown in Diagram 10, numbers are associated with 
the keypad. The numbers 5, 6, 7, 1 appear on the display 
as you press the associated key. 

2. SELECT UNITS appears, followed by the current unit of 

measure (U.S. STD or METRIC). Use an arrow key to 
switch between the options.

3. Press ENTER to accept the displayed setting.

The change will be retained in memory even if the EFX is 
turned OFF and unplugged.

4. Press RESET to return to the Precor banner.

EFX_Owners Manual.book  Page 43  Friday, June 16, 2006  9:25 AM