Campbell Hausfeld IN629500AV ユーザーズマニュアル
8
Operating Instructions and Parts Manual
www.chpower.com
Glossary
Become familiar with these terms before operating the unit.
AIR DElIVERY - A combination of psi and SCFM. The air delivery required by
a tool is stated as (number) SCFM at (number) psi. The combination of these
figures determines what size unit is needed.
a tool is stated as (number) SCFM at (number) psi. The combination of these
figures determines what size unit is needed.
AIR TANK CAPACITY - The volume of air stored in the tank and available for
immediate use. A large tank allows the intermittent use of an air tool with an air
requirement higher than the compressor’s rated delivery.
immediate use. A large tank allows the intermittent use of an air tool with an air
requirement higher than the compressor’s rated delivery.
ASME SAFETY VAlVE * - This valve automatically releases air if the tank pressure
exceeds the preset maximum.
exceeds the preset maximum.
ClICK-TO-SET REGUlATOR - The regulator controls the amount of air pressure
released at the hose outlet to the proper amount needed to operate an air tool or
spray gun.
released at the hose outlet to the proper amount needed to operate an air tool or
spray gun.
CUT-IN/CUT-OFF PRESSURE - Specific psi at which a compressor starts and
stops while refilling the air tank.
stops while refilling the air tank.
EASY DRAIN KNOB - This knob is used to drain moisture from the tank daily to
reduce the risk of corrosion.
reduce the risk of corrosion.
FOOT PEDAl ON/OFF SWITCH - Used to turn the compressor on and off. Press
firmly.
firmly.
MOTOR PROTECTION - If the unit is over worked, a thermal switch will shut
unit off. If this happens, turn unit OFF the ON/OFF Switch, wait 30 minutes to
cool, turn ON the ON/OFF Switch again to resume work.
unit off. If this happens, turn unit OFF the ON/OFF Switch, wait 30 minutes to
cool, turn ON the ON/OFF Switch again to resume work.
OUTlET (TOOl) PRESSURE GAUGE - Displays the current outlet pressure to the
tool in psi. It is regulated by the regulator knob.
tool in psi. It is regulated by the regulator knob.
PRESSURE SWITCH -Shuts the compressor off automatically when tank
pressure reaches the maximum preset pressure. The compressor will
automatically restart when it reaches the minimum preset pressure.
pressure reaches the maximum preset pressure. The compressor will
automatically restart when it reaches the minimum preset pressure.
PSI (POUNDS PER SqUARE INCH) - Measurement of the pressure exerted by
the force of the air. The actual psi output is measured by a pressure gauge on the
compressor.
the force of the air. The actual psi output is measured by a pressure gauge on the
compressor.
SCFM (STANDARD CUBIC FEET PER MINUTE) - Sometimes called CFM (Cubic
Feet per Minute). Measurement of air volume delivered by the compressor.
Feet per Minute). Measurement of air volume delivered by the compressor.
TANK PRESSURE GAUGE - Indicates tank pressure in psi.
TOOl STORAGE - The open space on top of compressor is designed for tool
storage. Specific Campbell Hausfeld tool kits will fit in this storage area.
storage. Specific Campbell Hausfeld tool kits will fit in this storage area.
* ASME: American Society of Mechanical Engineers. ASME tanks are
manufactured to ASME requirements.
Figure 3 - ASMe Safety Valve
Figure 5 - easy Drain knob
Figure 6 - Foot Pedal on/oFF Switch
Figure 7 - tank Pressure gauge
Figure 4 - Click-to-Set regulator