Carson Optical ED1928 プリント

ED1928 Mounting Bracket Kit  Installation Manual 

CP5064A 

Page 2 of 2 

04/20/10 

 
The following are the recommended steps to install the LBH-100 speaker 
onto a Dodge Charger using the ED1928 mounting bracket kit. 
 
The speaker is mounted in the general area shown in Fig. 1 located 
behind the grill. 
 
1.   Fig. 2.  Prepare the speaker/bracket assembly by installing the Clip 

On nuts over the holes on the top of the bracket.  Then mount the 
bracket to the speaker using the bolts supplied with the speaker.  Set 
the 15 degree angle between the speaker and the bracket as shown 
and tighten the bolts.  The speaker wire may be oriented up or down 
depending on desired wire routing. 

 
2.   Remove the plastic covers above the grill area to each side of the hood latch. 
 
3.   Fig. 3.  Mark the position of the hood latch assembly before removal so that it 

can be re-attached in the same position.  Remove the assembly via the two 
mounting bolts and position the assembly out of the way as shown in Fig. 4. 

 
4.   Fig. 4.  Remove two of the plastic mounting pins as shown. 
 
5.   Make sure area around, under and to the right of the hood latch access hole is 

free from wiring and cables. 

 
6.   Fig. 5.  Insert speaker/bracket assembly through hood latch access hole and 

position with Clip On nuts on bracket just below the empty mounting pin holes.  
Attach with supplied 2-1/2” bolts through holes into Clip On nuts. 

 
7.   Wire the speaker as described in amplifier manual.  Be sure to route wire to 

prevent wear, overheating and interference with air bag deployment sensors. 

 
8.   After wiring re-attach hood latch assembly at the position previously marked.  

Check for proper hood latch operation and that the hood latches properly.  Once 
installation is complete, re-install plastic covers to each side of hood latch. 

 

Fig. 1 

Fig. 2 

Fig. 3 

Fig. 4 

Mounting Pins 

Fig. 5