Patton electronic 10100 ユーザーズマニュアル
SmartNode 10100 Series Quick Start Guide
5
4.0 Connecting to the PSTN Network
A SN10100 with 8 RJ48C type ports enables the connection to T1/E1 lines.
Note
T1/E1 ports are activated by software license; the number of active ports
depends on the licenses purchased.
1.
Start with port 0, located at the top and leftmost position. Connect one cable between this port and the
T1/E1 line.
T1/E1 line.
2.
Repeat step 1, using the next available port.
Figure 3.
Port Interface to the PSTN
5.0 Connecting to the Power source
5.1 AC Power
The SN10100 connects to two independent power sources. If only one power source is used, press the green but-
ton at the rear of the unit to disable the audible alarm.
ton at the rear of the unit to disable the audible alarm.
1.
Connect an AC power cable between the AC connector of the SN10100 and an AC supply.