Radio Shack 15-1925 ユーザーズマニュアル
Need help? Call 1-800-950-7044
8
SETTING UP THE 6 IN 1’S RF
COMMAND CONSOLE
COMMAND CONSOLE
After you install batteries in the 6 in 1, just plug the
RF command console’s power cord into any stan-
dard AC outlet in the same room as your IR re-
mote-controlled devices (TV, VCR, cable box,
and so on) and fully extended its antenna. Be
sure the command console is pointed at the de-
vices you want to control.
RF command console’s power cord into any stan-
dard AC outlet in the same room as your IR re-
mote-controlled devices (TV, VCR, cable box,
and so on) and fully extended its antenna. Be
sure the command console is pointed at the de-
vices you want to control.
The command console has a 4-foot IR signal ex-
tension cord for use with devices that are not in
the command console’s line of sight. If you have
such a component, plug the extension cord into
the back of the command console and use the
supplied double-sided tape to attach the exten-
sion cord’s LED over or next to the device’s IR
sensor.
tension cord for use with devices that are not in
the command console’s line of sight. If you have
such a component, plug the extension cord into
the back of the command console and use the
supplied double-sided tape to attach the exten-
sion cord’s LED over or next to the device’s IR
sensor.
Note: The 6 in 1 transmits both IR and RF signals
at the same time. When testing the command
console, be sure the 6 in 1 is not pointed at your
devices.
at the same time. When testing the command
console, be sure the 6 in 1 is not pointed at your
devices.
LIGHTING THE KEYS
Press
to light the keys on the remote. Now,
every time you press a key, the 6 in 1 lights up
and stays lit for about 5 seconds.
and stays lit for about 5 seconds.
To turn off the light, press
again.
15-1925.fm Page 8 Monday, July 19, 1999 12:59 PM