Radio Shack 15-2127 ユーザーズマニュアル

ページ / 4
©
 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks 
used by RadioShack Corporation.
15-2127
OWNER’S MANUAL — Please read before using this equipment.
Thank you for purchasing the RadioShack 3-in-1 Universal Remote Control – Golfbag Style. It 
is a state-of-the-art device specially designed to operate the major functions of your television 
(TV), video cassette recorder (VCR), and cable converter (CBL). It is compatible with most 
popular brand TV, VCR, and CBL devices. The remote is pre-programmed before you 
purchase it. Input the correct code for your device and the remote is ready to use.
+056#..+0)"
$#66'4+'5
Your remote requires two AA batteries (not 
supplied) for power. For the best 
performance and longest life, we 
recommend RadioShack alkaline 
batteries.
.
.
.
.
1. Unseal the flap on the remote, then pull 
out the battery compartment.
2. Use a Phillips screwdriver to loosen the 
screw on the battery compartment 
cover, then remove the cover.    
3. Place two AA alkaline batteries in the 
compartment as indicated by the 
polarity symbols (+ and –) marked 
inside.
4. Replace the cover and secure it with the 
screw. 
5. Replace the battery compartment and 
seal the flap. 
±
±
±
±
241)4#//+0)"6*'"
4'/16'
While programming, make sure to aim the 
remote at the device and that the distance 
between the remote and device is within 21  
feet (7 meters).
1. Refer to the “Code List” on Page 3 and 
write down the codes for your device.
2. Manually turn on your TV, VCR, or 
cable converter.
3. Press 
TV
VCR
, or 
CBL
 to select the 
desired device type. The red LED blinks 
once.
4. Hold down 
SET
 until the red LED blinks 
twice. 
5. Enter the 4-digit code. If the code is 
valid, the red LED blinks twice.
6. Aim the remote control at the device 
and press 
PWR
. The device should turn 
off. 
±
±
±
±
 
#
"+/2146#06"
#
If an icon appears at the end of a paragraph, 
go to the box on that page with the 
corresponding icon for pertinent information.
— Warning 
 
°
°
°
°
 — Hint
.
.
.
.
 — Caution 
 
±
±
±
±
 — Note
#
 — Important
SET — Initiates 
programming mode.
PWR — Turns the selected 
device on or off.
TV/VCR/CBL — Selects the 
desired device type.
TV/VCR — 
Switches the 
view between 
the TV and VCR.
VOL
++++
/
VOL  Adjusts 
the volume. 
MUTE — Turns the sound on 
or off.
CH
++++
/
CH– Selects a channel.
#
#
#
#
 — Rewind
çççç
 — Record
ENTER — Press after entering 
channel numbers (on some TV 
models).
JJJJ
 — Play
''''
 — Stop
f
ff
f
 — Pause
,
,
,
,
 — Fast Forward
Battery Compartment
RESET — Resets stored 
remote settings.
R
"9#40+0)"
R
"
Dispose of batteries promptly and properly.
.
"%#76+10"
.
• Use only fresh batteries of the required size 
and recommended type.
• Do not mix old and new batteries, different 
types of batteries (standard, alkaline, or 
rechargeable), or rechargeable batteries of 
different capacities.
• If you do no plan to use the remote control 
for a month or longer, remove the batteries.
• Rechargeable batteries are to be removed 
from the remote before being charged.
• Rechargeable batteries are only to be 
charged under adult supervision.
• Batteries are to be inserted with the correct 
polarity.
• Do not short-circuit the terminals.
• Do not attempt to charge non-rechargeable 
batteries.
±
"016'"
±
"
Installing Batteries
When the remote stops operating properly, 
replace the batteries within 10 minutes of 
removing the old batteries. Otherwise, the 
programmed settings and codes will be lost. 
Programming the Remote
If the device does not turn off, repeat steps 
3–5, using another code from the Code List for    
your device until you find one that works.
5/KP/3"7PKXGTUCN"4GOQVG"%QPVTQN"L")QNHDCI"5V[NG