Honeywell UDC 3300 ユーザーズマニュアル
216
UDC 3300 Controller Product Manual
4/00
Function
Press
Result
Viewing the number
of cycles left in the
program
LOWER
DISPLAY
until you see
Upper Display
“R” and the PV value
Lower Display
RECYC XX
Remaining Cycles 0 to 99
This number does not
include the current partially
completed cycle.
This number does not
include the current partially
completed cycle.
End Program
When the final segment is completed, the “R”
in the upper display either changes to “H” if
configured for HOLD state, or disappears if
configured for disable of setpoint
programming.
in the upper display either changes to “H” if
configured for HOLD state, or disappears if
configured for disable of setpoint
programming.
The controller operates at the last setpoint in
the program in automatic or will be in manual
mode at the failsafe output.
the program in automatic or will be in manual
mode at the failsafe output.
Power-up state
The program will be placed in HOLD mode at the beginning of the
program at the local setpoint value prior to the beginning of the program.
program at the local setpoint value prior to the beginning of the program.