Konica Minolta VI-910 ユーザーズマニュアル
199
Chapter
2
Build
Menu
Menu
9i
910
900
700
300
910
900
700
300
n
Rotating the Element(s) by Entering a Value Directly
To rotate the element(s) by specifying the rotating angle, follow the procedure given below.
Note
If
Build – Rotate – Elements mode was activated using the shortcut key, the element(s) cannot be moved by this method.
Operating Procedure
The following steps must be carried out in Build – Rotate – Elements mode.
1
Click the right mouse button.
The [Build-Rotate-Elements] dialog box will
appear.
appear.
2
Select X, Y or Z to be used as the pivot,
and enter the desired rotating angle.
3
Click the [Apply] button.
The selected element(s) will rotate by the
specified angle.
specified angle.
• If you change the angle and click the [Apply]
button, the element(s) will rotate again according
to the new angle. The new angle will not be added
to the previous angle. It is an absolute angle from
the original position.
to the new angle. The new angle will not be added
to the previous angle. It is an absolute angle from
the original position.
4
Click the [OK] button.
The [Build-Move-Points] dialog box will close,
movement of the point(s) will be confirmed,
and the
movement of the point(s) will be confirmed,
and the
Build-Move-Points mode will be
canceled.
• Clicking the [Cancel] button will cancel all the
operations that have been performed since the
dialog box was opened.
dialog box was opened.
Build – Rotate – Elements