Konica Minolta VI-900 ユーザーズマニュアル
n
Recognition of the VIVID digitizer by the computer
The first time the VIVID digitizer is connected to the computer, cause the computer to recognize the VIVID digi-
tizer as an external device by following the procedure below.
tizer as an external device by following the procedure below.
Note
It is not necessary to install the device driver of the VIVID digitizer on the computer; however, Polygon Editing Tool cannot
control the digitizer until recognition has been completed.
control the digitizer until recognition has been completed.
Operating Procedure
1
After connecting the digitizer to the
computer, switch on the computer.
The digitizer will be recognized by the
computer as a new external device, and
then the Hardware Wizard will start.
computer as a new external device, and
then the Hardware Wizard will start.
2
A dialog confirming whether or not to
connect to Windows Update will ap-
pear first. Check the “No, not this time”
checkbox and then click “Next”.
pear first. Check the “No, not this time”
checkbox and then click “Next”.
3
When a dialog for confirming the driver
installation method appears, check the
“Install from a list or specific location
(Advanced)” checkbox and then click
“Next”.
“Install from a list or specific location
(Advanced)” checkbox and then click
“Next”.
Chapter
1
Preparations
14